Sig-sauer SSG 3000 User Manual download pdf (Page 49)

www.sigsauer.com

9.0 Assembly

CAUTION! Rifle may be damaged. Only assemble cleaned Rifle parts.

9.1 Fitting the barrel

CAUTION! Rifle may be damaged

• Do not use force when inserting the barrel into the magazine tube.

• Tighten the clamping screws until the spanner supplied begins to flex slightly.

• The spanner must not be extended by attaching a tube.

• If a torque spanner is used to tighten the screws, apply 62-71 lbs-in / 7-8 Nm.

1. Insert the barrel 400 from below up to the stop into the clamping device.

Ensure that the barrel is aligned in such a way that the insert remains easy to

move all the time.

2. Place insert 308 from below up to the stop into the receiver.

3. Turn the barrel until the insert engages in the barrel groove.

4. Install clamping screw 306a.

5. Lightly tighten clamping screws 306, 306a.

6. Install and close the bolt (see section 5.6.3).

7. Check the bolt action with the Rifle unloaded.

8. Alternately tighten up the clamping screws in sequence front-center-rear to

10-12 Nm (88-106 lbs in).

306 306a 400

Figure 18

308

14SIG1027_OM-SSG3000-USA_MiniManual_PeaseREV05.indd 49 3/27/14 11:17 AM

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 71 72

No comments

Sig-sauer SSG 3000 User Manual Page 49