Sig-sauer SSG 3000 User Manual download pdf (Page 41)

www.sigsauer.com

5.8.2 Setting the trigger position

Refer also to Figure 8. The trigger 710 can be displaced along the longitudinal axis by set screw 711.

1. Slacken off set screw 711.

2. Shift the trigger 710 to the desired position.

3. Tighten the screw 711.

Caution:

• Ensure that in the foremost position, the trigger does not contact the unlock slide 708.

• In the rearmost position, the trigger may not be located more to the rear, if the trigger begins to cover the adjusting

screw 709a. Otherwise this could hinder the correct function of the trigger action; in the worst case, firing a shot is not

possible anymore.

5.8.3 Setting the let-off point

Earlier let-off:

– Turn set screw 709a clockwise.

Later let-off:

– Turn set screw 709a counter-clockwise.

Note:

• To be able to adjust the let-off point, the trigger 710 must be in a position that allows access to set screw 709a.

14SIG1027_OM-SSG3000-USA_MiniManual_PeaseREV05.indd 41 3/27/14 11:16 AM

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 71 72

No comments

Sig-sauer SSG 3000 User Manual Page 41