Sig-sauer P226 X-Five User Manual download pdf (Page 15)

26 USA 27USA

Hinweis

10 Pistol Service and Repairs

10.1 Cause and correction of malfunctions

Malfunctions can be prevented with the proper mainte-

nance of the pistol (cleaning and inspection). Should,

however, a malfunction occur while ﬁring, proceed as

follows:

•

Hold the pistol pointed in the ﬁring direction

(safe direction) and take your ﬁnger from the trigger

while you carry out the steps described below.

1. Remove magazine and deposit safely.

2. Draw slide 50 back until stop and arrest it in the open

position by pushing up the slide catch lever 26.

3. Check (visually and manually with appropriate aid) to

ensure that there is no round, bullet, case or foreign

matter in the chamber or in the barrel (see section 3,

page USA 10). If a blockage is lodged in the barrel

bore, strip the pistol (see section 8.1) and have the

blockage removed by a qualiﬁed gunsmith using the

proper tools.

4. Remove all rounds, cases or foreign matter. Clean,

lubricate and assemble the pistol (see section 8.3/8.4).

5. Have pistol checked by a gunsmith or armor.

Warning

Service, Repairs and WarrantyService, Repairs and Warranty

Hinweis

Assembly/Malfunction

Ammunition feed:

No round chambered.

Slide:

Slide does not close properly.

Possible Cause

Magazine is not inserted correctly,

deformed or dirty.

Pistol or rounds dirty or lubricated

too much.

Pistol defective.

Possible Remedy

Insert magazine correctly or

replace it.

Strip, clean and lubricate pistol (see

sections 8.1 – 8.4), clean or replace

ammunition.

Repair by manufacturer.

Case ejection:

Empty case remains in the chamber

or gets stuck in ejector port.

Misﬁre:

Hammer strikes but no discharge.

Recoil insufficient because of fouling

with dirt.

Underloaded ammunition.

Pistol defective.

Firing pin sticks in the ﬁring pin

guide.

Defective ammunition.

Pistol defective.

Strip, clean and lubricate the pistol

(see sections 8.1 – 8.4).

Replace ammunition.

Repair by manufacturer.

Strip, clean and lubricate the pistol

(see sections 8.1 – 8.4).

Have pistol checked by armor.

Manually cycle slide to chamber a

new round.

Repair by manufacturer.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21

Comments to this Manuals

No comments

Sig-sauer P226 X-Five User Manual Page 15

Comments to this Manuals

Related products and manuals for Sports and recreation Sig-sauer P226 X-Five